Interested to Buy Any Domain ? << Click Here >> for more details...
what split ratio in gas chromatography.
- 9 Answers
- 50254 Views
- Cipla, Glochem, I also Faced
- E-Mail Answers
Answer Posted / rohith
capilarry columns are easily overloaded by injection of high volume of analyres to minimize this we use spit4 dat samples
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Why potassium dichromate is used in calibration of uv?
I have compare C2H2-air and C2H2-N2O flame AAS on determination calcium. Both use same range of std to plot calibration curve. (2-6ppm) When i measure the sample with phosphate, KCl and LaCl, C2H2-N2O flame give false positive result, around 0.5ppm. When i measure the sample with phosphste, KCl and EDTA. C2H2-N2O flame also give 0.5ppm false positive. But both above mentioned sample would not give false positive when measured by C2H2-air flame. What is the reason?
What is rs test why we are performing rs test?
why cone formation during dissolution?
what is the principle of UV Vis spectroscopy, AAS, ICP OES,ICPAES, ICP-MS and FTIR
What is the use of tlc and hplc? And when and where use?
For standardization of volumetric solutions, acceptance limit for concentration is considered as 10% of nominal concentration and %RSD as NMT 0.2% (for appropriate no. of replicates). But , if %RSD has not met, what should be further action?
what is the acceptance criteria for enteric coated tablets in 0.1n hcl validation in each parameter?
Why only Copper standard is used to calibrate Atomic Absorption spectrophotometer?
How to calculation of residual solvent methanol (3000 ppm) standard solution, and how many quantity used of test sample
how can give the expiry period and restadardisation of volumetric solution
if you have given one product then how you determine the impurity in that?
in hplc chromatogram started from left to right and in uv spectrum started from left to right
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
what is the principle involved in turbidometry and nephelometry ?
