Interested to Buy Any Domain ? << Click Here >> for more details...
My ups output shows 230 v between phase and neutral,but show
zero between phase and earth.Is the system/installation is
correct.If not what will be the possible reasons
- 4 Answers
- 5884 Views
- I also Faced
- E-Mail Answers
Answer Posted / akot
there should be out put between phase and earth unless the
earth is also having current or improperly done, to rule
out if your earth is having current measure earth to
neutral.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What is the size of a 60 watt and 80 watt tubelight?
I am shobana from Chennai. I am having my personal interview on 19th Dec at Chennai.kindly mail me the questions to mail id shobana.shanthi@gmail.com
What is the principle of HIGH SPEED DIRECT DRIVE MOTOR ?
what is the difference between fault current ant short circuit current?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What is the difference between diode and a transistor in terms of the direction of current flow?
Dears we deal in Chemical are Plate earthing. Kindly call if any requirement and questions. Tech Earth Solutions Mohit Verma 8791071007
what is effect of leading power facter on the system and billing
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
How would your past experience translate into success in this job?
What is meant by stator? What is meant by rotor?
will 1050kva DG set withstand for back charge of 16MVA transformer
what the Microsoft .NET framework is?
