Interested to Buy Any Domain ? << Click Here >> for more details...
My ups output shows 230 v between phase and neutral,but show
zero between phase and earth.Is the system/installation is
correct.If not what will be the possible reasons
- 4 Answers
- 5877 Views
- I also Faced
- E-Mail Answers
Answer Posted / hemalatha
earthing point where you checked may not be perfect.
| Is This Answer Correct ? | 6 Yes | 4 No |
Post New Answer View All Answers
HOW TO DESIGN THE body EARTH cable(Copper Conductor) size for 60KVA UPS?
List the power rating of any 5 important electrical appliances used in houses.
harmonics filter
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
What is meant by impedance? difference between high & low impedance ?
What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?
what is different between phase and netural
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
1. transformer design formula ? 2. how to calculate the primary turns and secondry turns ? 3. core types ? 4. how to find the primary current and secondry current ? 5. how to calculate the stacking factor ? 6. range of fulx density ?
what is inverter and converter
in my working site. momentary jerck in electrical supply ocurred frequently which cause of multiple losses in our electrical equipements. how can we protect our electrical machines and equipements in this situation.
