Interested to Buy Any Domain ? << Click Here >> for more details...
Anybody know how to create a ladder programme for power
switch in TV remote without using counter... ie TV can be
turn on and turn off using single push button switch... on
pressing the switch first time TV turn on and hold the on
state till i press the switch again, and after TV turn off.
- 2 Answers
- 4721 Views
- I also Faced
- E-Mail Answers
Answer Posted / mohanapriya
npn transister can be designed to solve this problem.
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
we have level transmitter for h2s04 storage tank capacity 10k ,always there are failure of transmitter due to failure of magnetic floats ,please come up with solutions at the earliest.
when a magnet is heated?
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
If fire would be inside the plant which fire detector is to detected the fire.
Hello to all....I am an Instrumentation Graduate and i am passed out in this year only.. I am unable to find the job in my core instrumentation.. so any boby tell me how to and where to search the job....please...and also tell me i there are any courses offered in the instrumentation stream so i can do it... you can send your suggestions to my mail-id i.e Ganesh20084u@gmail.com ... please..
What is loop1 and loop2 in MTS LT?
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
how we are selecting instuments by differentiating certain instruments in 4 to 20 ma range and certain in 1 to 5 v dc
Positioner usage.
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
