Answer Posted / jatin
commissioning of instrument has to deal with many steps. Availability of Cable tray and trenches. Laying of cable from Instrument to Junction Boxes and then Junction Boses to Marshalling Cabinet, which are connected with DCS/PCS controller. After laying of cables termination has to be done. which can be checked with the continuity of cable. the commissioning of instrument is still pending. The loop checking has to be performed for successful commissioning.
Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
what is the input to be given in digital flow meter during the the calibration time?
what is the reset offset and control system in instrumentation
i am from instrument branch i want paper patern of mahagenco . any pevious years paper regarding my branch send me please . please.....
in valve is constructed as per SME B 16.34, then which standard is used for fire testing of valve?.
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
what is diffrance between FF & SMART, explain with difination
what would be the minimum flow rate that we can measure on rotameter..?
State bernoulli’s application.
Which type of diagphram use in costic line,DM water line,natural gas line,oil line?
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
What types of Instrumentation Related Questions can an Interviewer ask in a Telephonic Interview ?
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
centrifugal compressor interlock? Tell me the parameter at which compressor will trip