Interested to Buy Any Domain ? << Click Here >> for more details...
what is exat meaning of compentation in RTD ? what diffrent
between 2 wire,2 wire and 4 wire RTDs?
- 2 Answers
- 8295 Views
- Atul, Vardhman, I also Faced
- E-Mail Answers
Answer Posted / vinoth
In RTD, we are measuring temperature through Resistance
change. Normally we are measuring this parameter in the
field. while transmitting, these signal to control panel
through cable, some additional resistance due to distance
will add upto the RTD resistance value. which shows
incorrect value. in order to overcome these, normally in 2
wire system, we will manual add/subtract some resistance
value with the measured resistance value.but it is no percise
whereas in 3 wire system, a parallely third wire run with
the two polarity wires, but its direction of current flow is
opposite to the other two. so it will cancel the line
resistance and give exact value. similarly, for more precise
and accurate measurement, we mostly use 4 wire system.
In above mentioned description, the addition of resistance
or removal of line resistance through extra wire is called
compensation for RTD
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
How to calibration a control valve?
How to work temperature gauge?
what does it mean an active front end in vfd plz explain it briefly
What are advantages and disadvantage of the ac supply load cell?
please tell me what is a light up procedure of Cfbc boiler and what it's axuillaries of cfbc boiler?
Calibration procedure for electro magnetic flow meter
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
Please any one can provide latest aptitude test,technical test and interview questions for tata consulting engineering (TCE) i need it asap thanks in advance
selection of the zener barrier for the hazardeous area zone 0
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
how do we commission inergen system?
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
can you provide me full detail about instrumentation in ONGC??
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
