I have a LT of 10000mmwc range. can i use this LT in 1000mmwc range of tank?? if yes than what happened???
- 3 Answers
- 6673 Views
- Nirma, I also Faced
- E-Mail Answers
Answer Posted / waqas ahmad
Your tx's range is 0~10000mmwc if u
use it at 0~1000mmwc head press tank
than it will indicate 10% level when tank
full. So just calibrate it (configure it) at
0~1000mmwc before take inservice for
actual reading of tank at output
| Is This Answer Correct ? | 17 Yes | 3 No |
Post New Answer View All Answers
Why are the uses 24vdc in industries
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
why fuse block is not used for AI signal?
Name different parts of a pressure gauge. Explain the use of hair spring in the pressure gauge.
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
Calibration of controller (pneumatic)
give eg of how I/P is used in control loops
How process line mpm calculation is done?
What is PDS and PDMS ?
how to check earthing,what is minum ohms for proper earthing
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
where proximity sensor installed on tank in loading arm application
Can combine control system for Emergency control system (ESD)and Fire & Gas System ( F & G) is possble to built and offer to client? Can such system is as per Norms in India?
Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?
for oil & gas industries which zone is normally preferred? why? give its example?
