Interested to Buy Any Domain ? << Click Here >> for more details...
why we do 2 types of earthing on tranformer ie:body earthing
& nutral earthing , what is function.
i am going to instal a 5oo kva tranformer & 380 kva DG set
what should the earthing value
- 8 Answers
- 32738 Views
- Altrion Technologies, I also Faced
- E-Mail Answers
Answer Posted / nitin naik
1)Body Earting:- It is a part of earthing process were we
are connecting the metallic part of the equipment to the
general mass of the earth (earth is a zero potential) to
ensure any leakage current due to failure of the insulation
of the active conductor. If it is not ensured & suppose
there is leakage current it may cause electrical shock to
the person touching the metallic part of the equipment.
2) Neutral Earting:- It is being ensured & essential where
we are installing distribution transformer (Delta to star)
& Three phase neutral DG set, Neutral earting is the
process of earthing the star point of the secondary winding
of transformer & star point of the alternator winding to
the general mass of the earth. It is essential to eliminate
the return current in neutral due to unbalanced voltage &
further to eliminate unbalance potential between the
circuits.
Note:- In both the case earth setups resistance should
below 2 Ohms.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
how we can decide that what value of ht line will come to any commercial building? (ans except According to the building load)
what is the practical application of full adder circuit?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
Do you need any help with FEWA Electrical Supervisor exams?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
EXPLIAN THE IMPORTANCE OF POLY PHASE CIRCUIT.
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
What is step signal?
What is force on a conductor in a magnetic field ?
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
wat is the first thing dat is needed, 2 lay a cable in some area??
where we use the SFU & FSU?
why sielent pole is used only in hydro generators and not in turbo generators
define the active power?
