Interested to Buy Any Domain ? << Click Here >> for more details...
why we take 4 to 20 mA as out put of every instrument like
pressure transmittre ?why we cant take 0 to 20mA as output?
- 6 Answers
- 10701 Views
- OGDCL, I also Faced
- E-Mail Answers
Answer Posted / caarpus
ABOVE MENTION IS CORRECT ANSWER.AT SAME TIME NORMALLY WIRE
CAN GIVE 1 OR 2 mA WHEN CONNECT TO ANY SIGNALLING
CIRCUIT.WITHOUT ANY INPUT THEY WILL PRODUCE THE MILL VOLT IS
WRONG ONE.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
Definition of reverse and acting controllers:
Isometric drawings are generated during _________________ phase of a project
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
what are the steps I have to deal with?
Hi,can anyone help me out with PhD programs related to Instrumentation field?I have a degree in electronic Instrumentation?
Explain about the leakage class of the control valves
which type of signal used in instrument?
why we take %i0.0 as input for twido plc
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
can you send remote seal interface level transmitter calculation steps for oil water saperator.
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
