Interested to Buy Any Domain ? << Click Here >> for more details...
how much the voltage & resistance should be ,between earth
& neutral points.?& why?
- 6 Answers
- 8366 Views
- I also Faced
- E-Mail Answers
Answer Posted / sheikh
i think voltage b/w earth and neutral should be zeero.
| Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
Which Class insulation is prefered for the sandwich Busducts ? Why?
what is the current setting for different relay protection for transformer .
what are inductive and capacitive voltage transformers.what are their applications
A jet of fluid strikes a plate What was the force required to counter it?
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
Define gain margin?
A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?
Mention the difference between Analogue and Digital circuit?
what is the range of maximum DOL and SDS can be use for pump and fan application
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
How is the gain affected by the introduction of feedback in a control system.
Why is the frequency not changed during transformation of electrical energy in a transformer?
Why efficiency in thermal power plant is low?
