Interested to Buy Any Domain ? << Click Here >> for more details...
what is upstream and downstream in liquid flow?
- 6 Answers
- 12108 Views
- Thermax, I also Faced
- E-Mail Answers
Answer Posted / mugil
flow level is going full ( high) in pipe line means that is
called upstream.
flow level is going low level in pipe line means that is
called down stream.
| Is This Answer Correct ? | 1 Yes | 16 No |
Post New Answer View All Answers
Why trim span ? How?
what is interface level measurement.who can calibrate interface level measurement transmitter online
Explain PID controller tuning & any one method used for it.
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Why are the uses 24vdc in industries
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
Explain about safety integrated level protection? . How it was differ from other protections ?
What is zone,loop/fire alarm system?
