if AVR fails in alternator. what will be the effect.
Answer Posted / emeka spark
I agree with Amritpal Singh Sidhu. i had similar
experience of AVR failure at the site few days ago and i
provided 12volts from the battery. innitially the voltage
was a bit higher than normal but i adjusted the governor of
the DG till i got a normal voltage.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
I am inpecting a 10kVA UPS what tests should i do and should i observe?
why using transformer and thyristor switch in 3 phase apfc panel
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
Define ohm’s law for a.c (alternating current)?
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
Please, if 1kw is equal to 1.25kva; how then do I know how many kva in 7.5kw?
What is reactance, reluctance,capistance, pls give answeer in hinglish and be simply Jo asani we smajh m aa jaye
What is an alternator impedance value?
when ac current flows thru d coil of a contactr,it energizes,magnetic field attracts d contact of the coil...nw wont dt ac current in d contct induce current back on to d coil thru mutual inductance leading to high currnt in d coil
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
how the aircraft outer body and inner body is separated ?
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
WHAT IS LOAD CELL