Answer Posted / nishwa
stat and stop operation,
to limit the starting current(star delta starter),
over load current and fault current and shot circuits current that current sense by relay,
variable speed operation
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
what about the power of wattmeter at starting and loding?
salam,hi, i need to know what the spesification of 300amp msb...
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
substation+ plc system
checking procedure of capacitor based motors.used in fans etc?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What do you mean by transformation ratio of instrument transformer?
what is upper impedance and lower impedance of a distance relay
What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
Differentiate between ideal and non ideal current sources?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
What are electric motors?
what is acceptance test in electrical engineering.
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
