Interested to Buy Any Domain ? << Click Here >> for more details...
Why shear forces are usually neglected in column design?
- 1 Answers
- 5464 Views
- I also Faced
- E-Mail Answers
Answer Posted / mohd ahmad
Because column is the
compression member
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
You have 3 snd sample of different FM=0.21,FM=0.95,FM=2.90 which one is suitable for a)plastering on R.C.C b)plastering on masonary wall c)concreting column d)concreting of bored pile.also justify your answer.
Design a cantilever slab to carry a live load of 2000 N/m2. The overhang of the slab is 1.20m. b) A slab over a room is 4.75m x 4.75m. The edges of the slab are simply supported and the corners are not held down. The live load an the slab is 300 Kg/m2. The slab has a bearing of 15cm. On the supporting walls. Design the slab as per Rankine - Grashoff theory. Assume weight of R.C.C. = 2400 Kg/m2.
in 2 way slab can additional compressive reinforcement can be provided if yes than in which conditions it is required ?
Why should appointment store person for project ? what is the benefits for company ?
what"s the sort of beams?
wat would be the probable interview questions and GD topics for IOCL exam?
what is the difference between replacement of cement by groundnut shell ash
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
which formula used for calculate the area of segmental arch?
What type of tensile strength is handling by crank in beam? Thanks.
How do You Maintain a structure after getting cube test of low strength.
std penetration resistance in very stiff clays lies bet 2 & 4 4 & 8 8 & 15 15 & 30
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
Which is the direction of negative angle?
how much concrete solid/hollow block are manufacture per 50 kg cement bag in differnent sizes like 400x200x200mm, 400x200x150mm, 400x200x100mm. And need proper ratio as per sale quantity. pls send my mail mathi7599@gmail.com searching last two years not yet get pls find and enclosed pls. need practical analysis.
