Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vino
Devices such as ultrasonic flow equipment use the Doppler frequency shift of ultrasonic signals
reflected from discontinuities in the fluid stream to obtain flow measurements. These
discontinuities can be suspended solids, bubbles, or interfaces generated by turbulent eddies in
the flow stream. The sensor is mounted on the outside of the pipe, and an ultrasonic beam from
a piezoelectric crystal is transmitted through the pipe wall into the fluid at an angle to the flow
stream. Signals reflected off flow disturbances are detected by a second piezoelectric crystal
located in the same sensor. Transmitted and reflected signals are compared in an electrical
circuit, and the corresponding frequency shift is proportional to the flow velocity.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
Calibration procedure for Electro magnetic Flow meter
we are using centum vp as monitoring with Dell precision work station T3600 but some times PC(s) are restarted automatically . how we can solve this problem? thanks
How the sizing of the analog signal cable is calculate?
please send data bank of quetions answers on analytical instrumentation.
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
Why the ammonia and Nitric Acid level indicators is with millimeter ? and What is the conversion form millimeters that level indicator indicate to weight ?
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
What is the difference between ff transmitter and non ff transmitter
hi,i am doing 3 year in electronic and instrumentation engineering. what type of aptitude questions will be asked in a core industries and how can i improve my skills in instrumentation?
What is difference of fanuc alpha series 16i and 18i controller.also what is differnce betn TC and MC controller
what would be the minimum flow rate that we can measure on rotameter..?
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
Can I calibrate the Electromagnetic Flow Meter on line and How.
