Interested to Buy Any Domain ? << Click Here >> for more details...
What are the safety devices in generator.
- 13 Answers
- 89214 Views
- ABB, Anand Group, ITC Infotech, I also Faced
- E-Mail Answers
Answer Posted / bikashrkl
normally u find safety device in generators are(above 500kw skl,daihastu 6DK28 1500kw,their are size of a container of truck)
1.-over speed trip,
1.1-underload trip(i.e u can see the load in -ve value ,genrator acts as a motor when parallel operation taking current from another generator)
2.jacket cooling water temperature high ,it will trip the generator and protect the generator being damaged by lack of cooling
3.overload trip.when load demand is higher than rated capacity(i.e ur generator capacity is 400kw but demand got high due to simultaneous starting of many machinsry or electrical items)
4.in some case u will find oil mist detector ,but provisons are there such as relief valve fitted on the alternate doors of crankcase not in all generators
5.low lube oil pressure alarm ,to protect the machinary .no l.o means overhating of running parts and consequence
6.low level alarm of lube oil in crank case.a float device is there to measure and if it is below critical level i.e low low level then it will trip the generator,as pump will not be able to take suction and lubrication of the bearing parts fail
7.jacket cooling water pressure low
| Is This Answer Correct ? | 40 Yes | 4 No |
Post New Answer View All Answers
Explain the uses of windmill?
What are safety considerations in welding job?
Is there a lower limit to the gland surface finish for static O-rings, gaseous system? surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?
what is procedure of measuring operating length of mechanical seal . (in case of centrifugal pump)
What is the difference between hydraulic oil and engine oil?
how the magnetic trains are leviated(MAGLEV)?
Can we integrate the C programming with Pro-e (modelling software)through application program?
Why an increase in area is required to produce an increase of velocity in case of supersonic flow ?
Where can you find the feed check valve and feed stop valve and give the purpose of it?
1.how to Ask the result After the interview gone? 2.please send me the interview questions of unigraphics,IDEAS,solidworks,autocadd,and mechanical design. to my mail id austinsobanam@gmail.com
What is the differenc between total moisture and inherent moisture in coal ?
what are the activities to be done after a steam turbine trips?
What is dtsi? Why it is used in motor bikes?
What is a bearing?
I am not sure about the syllabus of the BHEl esam for the post of Engineer trainee so I want to know it and also send me model question papers
