Interested to Buy Any Domain ? << Click Here >> for more details...
What is full form of G.O.D in 11kv distribution?
- 10 Answers
- 85859 Views
- GOD, MSEB, Shyam Indus Power, STL, I also Faced
- E-Mail Answers
Answer Posted / anantha murthy manja
It is Group Operating / Gang Operating Device. Both are correct.
| Is This Answer Correct ? | 80 Yes | 17 No |
Post New Answer View All Answers
How can we checked Killo Watts of Motor & Alternator?
when we have to use UPF wattmeter and LPF wattmeter? what is the difference between UPF and LPF wattmeter in terms of construction?
what is the difference between electrical and electronic choke?
what is the purpose of high speed earth switch in gas insulated substat
i have to install a HT panel, what components, I have to use in this and what will the diagram of that diagram,please tell me each and everything.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what is the function of bearing in dc mchine" and where it is placed
How to Calculate KA Rating of Main LT Panel
Define reserve-generating capacity?
why impudance relay used for medium transmission power system? why not others?
I have motor of 3 H.P. How i found the rating of capacitor use in it in single phase motor..???
What is meant by cold loop test in instrument
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
comparision between ACB and VCB
Capacitor is load free component but why ampere meter shows current when capacitor bank breaker close?
