Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between analog and digital
communications? which is the efficient communication??
- 6 Answers
- 85088 Views
- I also Faced
- E-Mail Answers
Answer Posted / muhammad awais
Analog
Analog systems are less tolerant to noise, make good use of bandwidth, and are easy to manipulate mathematically. However, analog signals require hardware receivers and transmitters that are designed to perfectly fit the particular transmission. If you are working on a new system, and you decide to change your analog signal, you need to completely change your transmitters and receivers.
Digital
Digital signals are more tolerant to noise, but digital signals can be completely corrupted in the presence of excess noise. In digital signals, noise could cause a 1 to be interpreted as a 0 and vice versa, which makes the received data different than the original data. Imagine if the army transmitted a position coordinate to a missile digitally, and a single bit was received in error? This single bit error could cause a missile to miss its target by miles. Luckily, there are systems in place to prevent this sort of scenario, such as checksums and CRCs, which tell the receiver when a bit has been corrupted and ask the transmitter to resend the data. The primary benefit of digital signals is that they can be handled by simple, standardized receivers and transmitters, and the signal can be then dealt with in software (which is comparatively cheap to change).
| Is This Answer Correct ? | 22 Yes | 12 No |
Post New Answer View All Answers
I AM DOING MY ELECTRONICS AND COMMUNICATION ENGINEERING.I NEED SOME SUGGESTIONS REGARDING THE COURSES THAT I CAN STUDY SO THAT I GET BETTER CHANCES FOR JOBS..WAITING FOR SOME SUGGESTIONS IN yamini1825@yahoo.com..THANK YOU
What is fbus protocol?
what is virtual grounding?
hai i need bhel model question paper for supervisor plz send this mail id bernatin@gmail.com
What is graticule?
What is dma channels?
what are the difference between dcs & plc & scada?
why BTS use 48 dc volt
write a c program for display 1 upto timers using for loop,do while loop,while loop
need previous placement test papers of infosys and soctronics
what is call flow!
how to work induction mooter
what is potetial,voltage,potential difference
plz give the question about interview to the post JR.Executive (ATC)
Which frequencies can't be used reliable beyond the horizon terrestrial communication without repeaters?
