Interested to Buy Any Domain ? << Click Here >> for more details...
Why the voltage n frequency of the incoming generator is kept slightly higher than d grid voltage n frequency while synchronization ?
- 4 Answers
- 13305 Views
- I also Faced
- E-Mail Answers
Answer Posted / raul
Theoritically it is like dat only dat the frequency n voltage of the incoming machine must match the grid frequency n voltage for proper synch, but practically it is kept slightly higher in order to reduce the impact on speed governor n automatic voltage regulator bcoz as the grid pulls d generator into synchronism, there is sudden load applied on d generator due to which there is a dip in both frequency n voltage of d generator which is 2 b corrected by the speed governor by opening d turbine valve more n more steam enters into turbine which corrects d dip in frequency n on d other hand d AVR corrects d dip in voltage by giving d signal 2 d pilot exciter to give more excitation 2 d rotor field winding of d generator.
I hope d concept is now clear 2 u......
| Is This Answer Correct ? | 9 Yes | 3 No |
Post New Answer View All Answers
whats the application of voltage regulation? and whats the voltage regulation's device?
what is the meaning of 0.5ohm Resistance
What is dynamo?How it works and what is the function of dynamo in a DG.
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
What are the advantages of skewing of cage rotor conductors?
how many load we can take for lighting
what does mean of RCT and STR in diffrential CT?
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
how to measure the transformer resistance values(dyn11)?and howmuch the minimum value?
How to measure power in 2 or 4 or n phase circuit? Please give me a formula.
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
how to identify the cable quality and what is flame proof cable
why in the three pin plug all 3 pins are cutted ?
what is method for testing CT
what is the Transformer Impedence?How can calculate?
