Interested to Buy Any Domain ? << Click Here >> for more details...
why we use tapechanger in primary side of transformer
- 5 Answers
- 9946 Views
- Bhel, L&T, I also Faced
- E-Mail Answers
Answer Posted / pradyumna171
current of primary side is low i.e smooth control gear is possible in this method of tapping that's why....
| Is This Answer Correct ? | 14 Yes | 6 No |
Post New Answer View All Answers
How cable from Kit-Kat to main switch, from starter to motor are designed?
draw 3 phase rectifier diagram
what is formula to cal cute earth pit numbers and size of earth strip used in earthing?
Why we use duplex coil and hook switch in telephone system?
Write the force balance equation of m ideal mass element.
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
Post possible questions for Power Factor Panel FAT / SAT
is it possible to have dc motors on single chip
What is the unit audit? if our Max demand is something and we found much more unit then how to improve our max demand?
Who are the manufactures those manufacturing 3Cx2.5sqmm FRLS cables. I heard about FRLS technology adopted only in wires useful for wirings
what are factors comes under relay setting (distance relay 7sa52) under OPEN DELTA VTs connection??
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
if you are in a software company,then why do you want to come in a core company like sail, ntpc(where lots of trouble like tension but you have a good life in a it company) ?
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
What is measurement?
