Interested to Buy Any Domain ? << Click Here >> for more details...
How can w select the cable size for different rating load
& also waht r factors affecting the during selection of
cable?
- 11 Answers
- 37684 Views
- AB Inc, Bosch, BRB Cable, Lucas TVS, Trisome Technical Services, I also Faced
- E-Mail Answers
Answer Posted / rathinam
My point of view, To find the cable size need to divide the
LOAD CURRENT by 3.
i.e:
Cable size= Load current (10A)/ 3
= 3.3
Now the answer is 3.3, But we don't have the 3.3 size of
cable. so we can choose next related size of cable, which
is 4 sq.mm.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
why we get 2 differnet values for power factor in 2 watt meter method in 3 phase
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
What will happen if a dc source is given to a tubelight. Will it work or wont it work....
plz explain the auot-reclosing circuit in electrical engineeing
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
why we use 630mm single core cable for transformer secondary side and why two neutral cable
what is a types of short circuit and what is a types of distance protection tests
What are the criteria shall be considers for sizing Fuse and MCB? If the rated current is 10Amps what should be the fuse size / MCB Size?
WITCH CARDS IN USE IN FIRE CONTROL PANEL.
how will reduce the voltage. if 12volt/250ma transformer toreduce 6 volt
What is the direction of current flow in ct secondary...means if the current is flowing from P1 to P2 then what will be the direction of current flow in ct secondaryw
What is step signal?
