how a.c. genarator control power factor when its conected
to grid supply by incrising or decresing excitation voltage.
- 1 Answers
- 2720 Views
- I also Faced
- E-Mail Answers
Answer Posted / sundar m
According to the P-f Q-v the reactive power supplied by the
machine will be depends on the excitation voltage so by
varying the excitation voltage without affecting the
synchronization of alternator we can vary the powerfactor of
the machine
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What does the term supermesh means?
EXPLAIN THE TERMS "INTEREST AND DEPRECIATION" AS APPLIED TO ECONOMICS OF POWER GENERATION.
does the Trivector Meter of three phase automatically takes care of the low power factor and gives the reading accordigly or it does not take care of the Power factor while giving the readings please explain
How much minimum insulation required between 11kv/3.3kv transformer windings?
1600kva capacity Transformers how the bucholz relay,Oil temperature,winding,surge relay relays setting are to be done
What is difference between unity power factor wattmeter and upper power factor wattmeter? In short circuit test of transformer the wattmeter used is unity power factor type or upper power factor type wattmeter?
Discuss the effect of sudden loading of an induction motor
what is the effect of higher value of GD???
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
what is tri state logic gate
Do closed loops systems require manual input?
Why neutral is not used in three phases dol starter
what is dry and wet frequency withstand voltage? why & where it is used??
How to derive detailed design of Suitable bus Bar for 100A for 6.6KV?
