Interested to Buy Any Domain ? << Click Here >> for more details...
what is the differents and advantages of Electro magnetics
relay and static relay ? what is the numerical relay ?
advatages?......
- 7 Answers
- 23984 Views
- CAT, L&T, TCS, I also Faced
- E-Mail Answers
Answer Posted / ud
1) static relay is stationary relay while em relay is movable.
2) power consumption in case of static relay is usully lower than em relay.
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
Why do we apply both Differential and REF (HV and LV) protection schemes on YNyn configuration of a transformer?
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
Differentiate between magnetic field and magnetic flux?
Hi.. I am a BE GRaduate in E&E. I have 8.5 Experience in Tendering & Estimation field. I have done SAP SD course few years back. But due to some reason i failed to get job in that field and continued my own field. Now I am thinking of changing into SAP seriously. How should i go ahead???
why the colour of insultor stack , petticoat is brown. Is it has some technical reason.
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
i have attended the interview on 4th June,08 at Kolkata in IOCL, can anybody tell me what is its result
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
HOW TO CALCULATE ELECTRICAL, MECHANICAL,& OVERALL EFICIENCY OF GAS ENGINE POWER PLANT
What is routh hurwitz stability criterion?
how to ctrl motor by use of ac or dc drive.plz explain evdintly
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
