Answer Posted / lokeshraj

We use the capacitor bank to maintain the power factor at .8 when it goes below this value, capacitor compensate the reactive power needed, and improves the power factor. Why don't we use this much value of capacitor that the pf becomes unity. Because if we use the capacitor at the load end and makes the pf unity the losses in the line will be decreased and the load capacity of the line will be increased.
Only in unloaded or lightly loaded condition the receiving end voltage of the line becomes higher than the sending end voltage.

If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these

1999

---

WHAT IS LOAD CELL

2143

---

how to calculate the lightning arrester conductor @ no of earth pits required

2115

---

How to measure the earth resistance value in a concrete pavement(flood light area)?

2203

---

What happened when capacitor connect series in ac circuit?

1485

---

what is effect of length of air gap on performance of dc motor and generator?

1878

---

how to select battery for 15 KVA UPS with formula

2539

---

Why are cables rated for 40 KA for 0.25 Sec fault current rating?

1945

---

draw a circuit diagram connecting transformer OLTC- RTCC- VCB-Marshalling Box otherwise Explain in words

23097

---

How to address the servo drive for motor

1992

---

What is the working principle of MIG welding? and its out put Voltage?

3303

---

design a LV scheme for a 15 storied building?

1942

---

Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not

1632

---

What is meant by load angle of an alternator? Upon what factors does the load angle depend?

2996

---

What is power relay?

1239

---