one MT of steel for using how much binding wire required?
- 5 Answers
- 7724 Views
- I also Faced
- E-Mail Answers
Answer Posted / arunachalam subiramani
One MT of steel consumed binding wire 5 kgs
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
During reclamation how can the occurrence of mud waves can be rectified?
What is packing Factor ?
Pls explain me about tension and compression in a flat slab
How can i display 5 asterisk and another 5 asterisk )?
Can anybody explain with the help of sketeches that what are 2legged , four legged & 6legged stirrups and how to calculate cut length of diamond ring(stirrups)?
For plate load test why we are applying pressure 3 times the proposed allowable bearing pressure? Is there any supporting standards for this?
material required for construction of 1cu.mtr wall (Cement, No of bricks (Brick size 40cm x 20cm x 10cm),sand,Quantity of water
I am a civil engineering student and going to attend interview in this week in an IT company.Will they ask me questions about my area of interest or cs
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
cement required for construction of 400mm*200mm*200mm concrete solid blocks for 1sq.mtrs,how?
is there any influence of water(used for mixing of concrete) on a weight of harndend concrete.
What is pre-stressed concrete?
How can we convert weight batch to volume batch for m30 mix
What happens when,in Prestressed girder the HDPE duct and cone size is provided more than required? (technical answer expected)
