Answer Posted / viraj
normally above voltage 10kv called voltage source
their are of two types
1.system generated
when ckt connected or disconnected
2.lightning
lightning stroke over the current caring conductor.
surge current means inrush current
it takes 5 to 10 times current when instrument starts for first time
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
what is x'mer ,isolation x'mer & yltra-isolation x'mer?????
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
Is there any reason that we get shock on touching phase wire because the earth is at neutral potential? Is there any reason that the earth is at neutral potential because the neutral is earthed in apower station
how desiel generate sart fail of eb?
Which types of gate insttaled in static switch. Please give me answer.
When MICC cables used ?
why the arc welding machines require parallel earthing systems? ie why each machines are connected to earth pit by separate wires during earthing? wats it adavantages?
What is advantages of VSCF wind electrical system?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
Two electric lamps 40 W, 220 V each are connected in series across 220 V. What is the power consumed by the connection?
what is allowable ac mixing in dc
what material is used in capaciter
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
State the methods of improving power factor?
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
