Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / priya
Let us consider a 11kv/433v 100KVA DTR; LV side current rating is 133.33A(100000/(1.732*433)). Now max loading on LV side is 133.33A in each phase. If loading on each phase is say 50A 50A 50A then load is said to be balanced. If loading is say 100A in Rphase 30A in Yphase and 20A in Bphase then the load is said to be unbalanced.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
how can calculation ate Amps for cabel. Ex-for 1sqmm wire hou many amps we can draw
for 4 MVA , 33K.V/6.6K.V transformer. secondary side the connected load is 3000H.P. What is the rating of capacitor bank to be insttaled.
what is meant by impulse voltage?
what is errection pcbs?
As you achieve greater success with the company after some years, Will you like to be a share holder in our company?
What is cathode ray oscilloscope (cro)?
what are the installation procedure of high voltage power transformer,CT,CB&PT?
what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering
What is the difference between PLC and Embeded system
How u can give the overload setting to any motor protection relay for a HT motors with formula and Example?
how cables go in and come out for distribution from the feeder pillar box?
