What are the Components of Siemens S7 300 Series PLC system ?
- 1 Answers
- 7936 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / nitin gomle
cpu(312IFM,313,314,315,2DP,316-2DP,318)
single module
DIGITAL I/O(SM321/322/323)
ANALOG I/O(SM331/332/334)
FUNCTION MODULE-(ex:-POSITIONING MODULE,CLOSED LOOP)
COMMUNICATION PROCESS-(ex:-CP342-5 DP FOR PROFIBUS)
INTERFACE MODULE-FOR INTERCONNECTING INDIVIDUAL RACKS(IM360/361,
IM365 S/R)
| Is This Answer Correct ? | 16 Yes | 0 No |
Post New Answer View All Answers
What are the uses of orifice plates?
why orfice is not used for main steam flow calculation
Calibration of controller (pneumatic)
What is Erosion in a control valve?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
can we copy the software from a transmitter using hht(hart 275) ?
what is The specifications for oriface instalation
what is the calibration procedure for magnetic flow meter @ onsite
Why ac supply load cell is used? Can we use the dc supply load cell?
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
State some of balance principle’ advantages?
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??
