Interested to Buy Any Domain ? << Click Here >> for more details...
one MT of steel for using how much binding wire required?
- 5 Answers
- 9254 Views
- I also Faced
- E-Mail Answers
Answer Posted / k t shivashankar
it is mainly based on design
avg we can take it as 5 kgs / tonne
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is the name of this multiplication factors ?
How to calculate laplength for 3 floors
what could be the production cost of 1 cum of concrete by CP30 plant
List out some of the software program that can be useful for architect?
suppose we have a tendency to make a hole on the surface of the simple supported beam, than where we goes to make it?
What is the basic difference between OPC
Define What is a kip?
Pile height is 4.3m. 2nos. under reammer. bulb nose is 75mm and height is 400mm. pile dia is 375mm and overall dia 940mm.pls. help to calculate concrete in pile and bulbs separately. What is formula for bulb volume calculation ?
Basic questions of civil engineering
what are the duties of Site Engineer in work site?
how much need cement bags for block work of wall approx 1000 hollow blocks 20x20x40cm
What is the cemnent ratio
difference between trapezoidal and pedestal footing and how the load acts on that
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
What is Joule Brayton Cycle?
