Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate kA rating of device?
- 3 Answers
- 14360 Views
- Siemens, Vijai Electricals, I also Faced
- E-Mail Answers
Answer Posted / gunesh urs k
KA Rating can be calculated by simple Ohm's Law.
I = V/R,
[where R value is calculated by formula ρl/a, ρ=Resistivity
of material of conductor, l=Length of the cable & a=Cross
Sectional area]
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
Why do we use copper cable for HT Supply and why not Aluminium?
can u please mail me the syllabus for GET exam for damodar valley corporation?
How does a television work?
What will happen if i replace a inductive proximity switch with photo sensor in a machine?
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
Define resonant frequency?
How is the gain affected by the introduction of feedback in a control system.
what is the difference between gas group b and gas group c electrical equipment construction wise?
What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
what is level 2 automation?
what purose of the double circuit transmission line phase of the line phase changed for circuit-1 for Circuit-2 R-Y-B B-Y-R
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
PLZ EXPLAIN CORONA,SKIN,BIRD PALE,SPAN,SAG Effects of power cable.
