Interested to Buy Any Domain ? << Click Here >> for more details...
What is the Difference Between MCCB & ACB & VCB
Answer Posted / ravikant sawant
MCCB,ACB,VCB all the three are protective devices only.
They are used to isolate the system which is connected
below them at fault conditions. Eg, Overload, Short
circuit,Earth fault.
MCCB - Operating on thermomagnetic principle, it's a very
compact taking less space can be used for low voltage 440
volts, up to 1000amps range.
ACB - Operating on electronic or microprocessor controller,
solenoid coil being used to isolate the system during fault,
it's takes more space as compered to MCCB & again it can
used for low voltage 440volts but up to 2500amps range.
VCB - Operating on electronic or microprocessor controller,
solenoid coil being used to isolate the system during fault,
it's takes more space as compered to MCCB & it can be used
for high voltage up to 33kv, above 33kv you go for SF6 breaker.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Define ampere
what is subtransient , transient and steady stateac components
distribution is maximum done by a)radial b)network c) parallel d)b & c
Define noise?
what are the principles of a booster converter?
how can we save enegry by using VFD for Resiprocating Air compressor which is having more unloading running hours
Why do we need interlocking in a HT metering or Ring main unit switchgear?
What is the effect on Power factor and capacitor when your company load is more than 70 % of welding transformer
why ct's&pt'S out put called as burden,why compelsary short ckt the secondary of ct's while removing the burden?
The specific heats of the gas at constant pressure and constant volume are respectively 1.0 kJ/kg K and 0.72 kJ/kg K; the value of R for the gas is
why ht cable end termination don't have a gland?
How is magnetic leakage reduced?
what are the dimensions for 200 kva transformer plinth (plateform),in which pcc m20 is used..
What is the instrument to check the rotating diode fuse of alternator in running conditions?
How to test IR testing & magnetic balance test
