Answer Posted / priyabrata
Anti pumping relay is nothing but it works as a protecting
device for close coil.It protects close coil for instants
operation when close command goes to breaker.Once breaker
get close comand it close but after closing if breaker gets
close command then anti pumping contactor prevents that.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???
what is high and low cut off voltage of BB and DG at SPS????????
HOW TO CALCULATE ELECTRICAL, MECHANICAL,& OVERALL EFICIENCY OF GAS ENGINE POWER PLANT
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
How can calculate the rating of a alternator for a given specific load with formula
what will happen if synchronous machine rotor fed from single phase ac supply
I have 440v power coming to facility,( not being used ) can I buy large generator, (gas) to sell power back to electrical co.
Why two phase welding machine is used instead of three phase welding machine.
What are the operation carried out in thermal power station?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
what is kvarh? Please define it With calculation General motors ?
What is servo lock in CNC how they work and if any parameter for them in CNC machine
The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s