why Transformers power mentioned in KVA?. and why Generators
and Motors power mentioned in KW?.
- 10 Answers
- 11966 Views
- I also Faced
- E-Mail Answers
Answer Posted / iyswarya sithanathan
The convention is that source power is mentioned in KVA and load power to be mentioned in KW.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
use of PIR in ehv breaker
How to decide CT & PT ratings for a given transmission line carrying some rated voltage?
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
how to interlock 3 incomer-ACB,1 buscoupler ACB,... pls answer this question and if possible send me the ckt diagram..haifriends2910@gmail.com
how power is generated,and transmitted to our home..pls explain briefly in simple words.
if any house we instaled a 1.5 ton ac and its phase cable of wiring is installed but netrual cable of wiring not instaed. my question is that is neutual of house(for other wiring is capable for ac load or a sepeart neutrual wiring required
what is rocking arrangement in arc heating
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
Why synchorised generators are used for the production of electricity?
What is difference between isolator and circuit breaker?
PLZ sent the previous year question paper for GET in NHPC on my EMail id ppshanker@gmail.com
how to size H.T & L.T Panel ?
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
How to calculate the volumetric capacity of a oxygen & Nitrogen gas Cylinder if pressure is 145 kg/cm2 & water capacity of cylinder is 67 liters.
