Interested to Buy Any Domain ? << Click Here >> for more details...
why the transformer neutral earthing is to be done by copper
flat only,if we use GI flat what is the disadvantage.
- 2 Answers
- 8637 Views
- I also Faced
- E-Mail Answers
Answer Posted / pradyumna chandra panda
Earth electrod should have low resistance and copper flate meet it. IF we use GI flate then potentional between earth &neutral will be increase on unbalance load, but it is allowed only 20 volt . we can decreare the earh resistance by increance the electrode in parallel.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
what is meant by residual over voltage & residual earth fault ?
why does the magnetic balance tests at transformer?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
why do we put a transformer on soak before loading it
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
what will be project cost for 100 kv transformer connection under oyt scheme.
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
Is there possible to Test Transformer for Overfluxing Capability. Or is there any firm who does Overfluxing Test on Transformer?
What is the fault or needs to be done when frequency in ac drives is not changing?
what is the minimum voltage require to injure our body?
sir, 3phase induction motor takes different pf and different KW in three phase while running,explain reason
i need the details about bhel exam.how to apply for that.please send to my email-id.thenmozhi2k7@gmail.com
how does grading rings & spacers in transmission line works? Working Principle?
