Whether the DP transmitter can be utilised in the medium of
Vaccum for the measurement of Level?
- 10 Answers
- 15879 Views
- I also Faced
- E-Mail Answers
Answer Posted / satya
WE USE DPT FOR HOTWELL LEVEL IN TURBINE EXHAUST ,STEAM WHAT
IS CONDENSATE IN CONDENSER AND COME TO HOTWELL . THE
CONDENSER WITH HOTWELL IN VACUM .
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
it is possible to check the fail safe condition in pressure transmitter. if possible how?
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
protection relay watchdog contact operation?
for oil & gas industries which zone is normally preferred? why? give its example?
Exothermic reaction./ endothermic reaction
How works weighfeeders in cement industry? what is the working principle?
What is the difference between PLC and DDC?
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
How d.p. Transmitter can be applied to close tank?
What is the difference between modbus,fieldbus & profibus
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
How does your previous experience relate to the job you are applying for ?
What is the use of single seated valve?
