Interested to Buy Any Domain ? << Click Here >> for more details...
Can CT Secondary left open circuited and why(reason)?
- 5 Answers
- 10424 Views
- I also Faced
- E-Mail Answers
Answer Posted / muhammad nazim
A CT is basically a step-up transformer(from voltage point
of view).In the case of 400/1 A CT the primary turn is 1
(say the busbar)and the secondary turns is 400.How much
will be the primary voltage drop?? it will be in millivolts
for a busbar.So this millivolts multiplied by 400 will
cause just around a few volts (say 3 to 10V) for an open
secondary.But i have read that the secondary voltage will
reach a few kilovolts for a 400/1A CT at full load
conditions.My question is how it will reach a few kilovolts
and damage the CT on open secondary condition?As we have
seen above the max voltage wil be just in few volts.So
please someone
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
how can i use REF and diffrencial relay both in 1 CT core for transformer protection?
please send me the previous year's question papers of jindal GET exams
is it possible to start a motor in felid connected to a remote mcc
what is PWM in IGBT and how it works for drive.?
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
What is pole of the system?
in Contactor opearation Why there is a difference in the values of the operate and release voltage in case AC supply
sir i applied for hpcl(electrical).i want to know from which subjects most of the technical que will b asked.and pattern of the written test.pls help me
how we findout a ignater is faulty or not?
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
List examples of voltage source?
what r PID controllers?why they r used?what is there purpose?plz Explain in detail
How to know of any cable size if there are not written on cabl?
