What is D check in a Diesel generator for 1000kva DG
- 9 Answers
- 36629 Views
- Escorts, I also Faced
- E-Mail Answers
Answer Posted / sanath shetty
D-check (Every 3000- 5000 Hrs.)
1. Complete DG set should be dismental.
2. Turbo charger service
3. Injector Pin service
4. Cylinder Head service
5. PT Pump sevice &
6. Repeat the B-Check process.
If your DG set running hours more than 10,000 then in D-
Check You should
1. Change Piston Bearing,
2. Change nozels,
3. Piston Cylinder also need to be change.
4. Change Canopy filter if require
5. Check polution level
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
Enlist four components of electrive drives.
r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā
how much LT load can bear by the 100 KW HT connection.
I AM GOING TO ATTEND APTRANSCO ON 26TH OCT 08.PLEASE SEND ME ANY MATERIAL OR TYPE OF QUESTIONS OR EXP QUESTIONS.
What's mean HVF & HAF in Vacuum Circuit Breaker?
How wire size can define in electrical wiring? What is the ratio?
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
How to calculate the efficiency of Turbo Generator(Alternator) in general....?
briefly explain the main blocks found in a microprocessor based system
3 phase Motor will be given 2 phase after 2 to 5 second we given 3rd phase so Motor Run sum-time in forward or sum time run reverse direction. All time phase sequence is not change. Why motor run in reverse direction? Please Explain........
If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.
which network topology offers the greatest level of tolerance?
any one guide me to reduce the power factor of diesel Generator from 0.97 Leg to 0.8 Leg.with out any change in my load.
How to measure power in 2 or 4 or n phase circuit? Please give me a formula.
