Interested to Buy Any Domain ? << Click Here >> for more details...
WHY WE NEED NEUTRAL FOR 3PH 400 OR 415 VOLTS POWER SUPPLY (4
WIRE SOURCE).
- 5 Answers
- 9473 Views
- I also Faced
- E-Mail Answers
Answer Posted / manikandan
in 3ph 415 vac 4wire system the neutral used for 1ph electrical equipment power supply. i.e. nominal voltage 230V 1 ph can be obtained between any one phase and the neutral.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
can anyone show me how the 3 phase power is supplied to socket outlets?
in single phase converter, the no.of scr's conducting during overlap a)1 b)2 c)3 d)4
Is it possible to protect 3phase overload and earth fault of the 3phase system using two CT's.
What is the diff. between single compression and double compression gland
State The Difference Between Generator And Alternator?
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
Earth leakage relay basic knowledge principle
how to test power transformer.YNd11
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
Draw the single line diagram of the power station?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
why on delay timer used for fully automatic star delta starter?
i want design of D.C.MOTOR 1HP 960RPM AND 2HP 960RPM ITS URRGENT
can any one know is sbi interview based on merit or based on roll number
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
