Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference between RTD , thermo couple and
thermistor in general ?? (except temperature co-efficient )
- 5 Answers
- 19344 Views
- Bilt, I also Faced
- E-Mail Answers
Answer Posted / elsayem
rtd use for low temperature
thermocpuple use for very high tempretue
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
what is the input of digital counter during the the calibration time?
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
what is exact time to study dcs and plc cources
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
all types instrumentation questions want
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
Hi, I am Newely Joined in Construction company instrument engineer? Any one can Plz tell me How can I advanced preparation for Releated Engineering and construction Documents?
what is basic difference between motion balance and force balance in pneumatic instrument?
what is interlock system and why we use of this?
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
Regarding , there is an air cooler which control the fans(50% of AV FANS) by temperature in outlet , and the louver of Air cooler is controlled by HIC from control system , So if on Air cooler we will consider 2 individual I/P converter or positioner?
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
