Interested to Buy Any Domain ? << Click Here >> for more details...
how do you calculate IKW(consumption per TR) in HVAC?
- 27 Answers
- 149528 Views
- Aircon, CBRE, Cipla, Clivet, Cushman Wakefield, JLL, Sodexo, Voltas, Wipro, I also Faced
- E-Mail Answers
Answer Posted / sandip bharne
1Tr=80x907/24 ( ice requires 80kcal/hr to melt,907 is US
short ton)
=3023 Kcal
1kw= 860kcal/hr
1TR =3024/860
1TR =3.51KW
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
Why are the cores of large transformers built up of circular transactions ?
WHAT IS THE SIGNIFICANCE OF VECTOR GROUPS IN TRANSFORMER? WHAT WILL BE EFFECT WHEN PHASE DISPLACEMENT CHANGES IN TRANSFORMER?WHAT IS THE NEED TO BE PHASE SHIFT CHANGE BETWEEN THE PRIMARY AND SECONDARY WINDING
WHY IS THE EARTH FAULT CURRENT ALWAYS LESS THAN THE NORMAL CURRENT??
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
How phase displacement change in the over current relay coils.
How many types of protection relays are there based on the characteristic?
How to calculate multiplying factor of dc energy meter
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
In 90 kva alternator that produce the output voltage is 115(p-n),200(p-p) at 1500 rpms means what ampere it produced ?
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
explain the types of drives
Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity
What is the exact formula for one weber of magnetic flux?
