How can we calculate the Rating of DG Set for a 4 kw motor?
- 3 Answers
- 4905 Views
- I also Faced
- E-Mail Answers
Answer Posted / samarpal singh
1.5 time of motor capacity
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
How to calculate the heat load for a electrical room
mccb service sittings be done?
what is the isolation transformer. what is the isolator?
How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter
L.A. (Lightening Arrester) is located at a place from where transmission line enters the transmitting substation. So L.A. (Lightening Arrester) is the first equipments which has to encounter with lightening, high voltage surges and switching surges. It has to absorb energy of lightening, high voltage surges, and switching surges. L.A. (Lightening Arrester) is made up of layers of semiconductors. If these layers can not tolerate energy released by lightening, high voltage surges, and switching surges the L.A. (Lightening Arrester) blasts.
what is package substation.how many types they have
Define ohm’s law for a.c (alternating current)?
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
Stator of 3-phase IM has 3 slots per pole per phase. If supply frequency is 50 Hz, calculate the speed of rotating stator flux A 1000 rpm B 500 rpm C 1500 rpm D 1440 rpm
What is the principle of HIGH SPEED DIRECT DRIVE MOTOR ?
how we arrange the hv side with delta connection in case 33/11kv of transformer.
how to caculate cable size for diff types of loads? if anyone know the calculating procedure please tell me
what is the meaning of number in (11, 31, 61,14, etc. CDG11, CDG31, CDG61, DDT32
why are installed water leakage detection system data centers & server rooms
