say a transformer is designed for 33/11kv step down with
ratio 0.33 for load 1 mva. if am giving 11kv as a input
that same transformer what will happen to its o/p voltage.
and whether it can be operated for 500kva
Answer Posted / reza
The trans act whit no happen.But we must use from reduced
load.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what are the components in electrical control panel (for example: 415V, 3-ph, panel to operate utility and 3-ph DG set).
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
How to calculate the Efficiency of Chiller
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
Why synchronous motor is used in power factor improvement,dc series in lift
What are the various types of BUSBAR Schemes? explain each
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
i want use the cable size 16cx4 core aluminium usege watts 240x2000w this cable size is correct?
What is boucholz relay and the significance of it in to the trformer?
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
what is spadar bar .why I use in DC generator.
what is counter poise conductors
Explain (in simple ) - root mean square. whats its role in electrical fundamandal.where its used