Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / eshwar y p
yes we can do it using two phase lines of 440v.Usually bulb is designed for 230v so by connecting two bulbs in series to get 440v amplitude and then connect this across phase lines the bulb will glow
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
What is the type of feedback used in an op- amp schmitt trigger?
how to calculate the change over time for star delta starter for different KW motor?
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
How to calulate Locked rotor amper(LRA) for compressor type motors?
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
How can we measure earthing resistance test (Earth meggar) of Transformer neutral pit while in live condition?.
what is residuel magnetism. and how order lead acid batteries for 24 volt. emergency lighting system.
How to select, design,size & calculate for 11 KV/33KV/66KV/132KV/220 KV/440 KV circuit breaker for HT side of transformer protection/HT distribution protection?
Why we use ups battery and dsdb battery in thermal power plant
what is a bus riser in power system and why it is used
how to calculate units consumption for a 12 hp motor /hr.
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
can we use engine degreaser for electrical motors?
What is meant by RVT and NDR ? expansion and details of it
