Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT ARE THE DFT AND RMS MEASURMENTS PRINCIPLE IN NUMERICAL
TECHNOLOGY OF POWER SYSTEM ?? WHICH IS BETTER IN WHICH
QUANTITY MEASURNMENT??
- 1 Answers
- 17359 Views
- I also Faced
- E-Mail Answers
Answer Posted / otto
RMS
The AC component is the effective mean value of the positive
and negative peak values.
RMS is used in applications where the effect of the DC
component must be taken
into account.
DFT
In the DFT mode, the fundamental frequency component of
the measured signal is numerically calculated from the
samples. In some applications, for example, it can be
difficult to accomplish sufficiently sensitive
settings and accurate operation of the low stage, which may
be due to a considerable amount of harmonics on the primary
side currents. In such a case, the operation can be based
solely on the fundamental frequency component of the
current. In addition, the DFT mode has slightly higher CT
requirements than the peakto-peak mode, if used with high
and instantaneous stages.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Diagram and details of polarity test for Current Transformer 11kv 400/200/100/1A
.php|
Why let through energy not considered for ACB breaker while cable sizing?
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
Meaning of ingrace protection for motor.for ex IPXY
can anyone explain 11kV 3core cable megger,hi pot test procedure with connection details?
What is size 00, 01, 1 etc., in HRC fuse types?
my diploma certificate in my higher education college
Why collecting electrode of ESP to be earthed
how to synchronize 3 phase slip ring induction motors of different ratings.
explain me the relation between torque, frequency,speed,voltage and current in the 3 phase induction motor?
What are all present producing cost of Per KWH of various Fuel?
what ispositive, negative, zero sequence impedence?
WHAT IS MEANT BY DERATING OF THYRISTOR?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
