Interested to Buy Any Domain ? << Click Here >> for more details...
difference between shunt coil and tripping coil
- 8 Answers
- 70256 Views
- GE, I also Faced
- E-Mail Answers
Answer Posted / sai srinivas
The purpose of shunt coil is only for remote tripping
purpose. Shunt coil is winded coil. MCB can be tripped manually by pressing one plastic liver connected to contacts. If the MCB need to trip not for Over load or other faults, this shunt coil will be used. For example if fire occurs in AC plant room then to avoid spread of flame the AC plant must switched off automatically. Then this shunt coil is used. Shunt coil is connected to neutral and phase is connected via fire protection panel i.e phase wire from MV panel goes to fire panel and return back to shunt coil. Under normal condition the contacts in fire panel will ne Normally open, under fire condition, relay in fire plant acts and NO contacts becomes NC and supplies to shunt coil and pushes the MCB lever. then MCB trips which switches off supply. So trip the breaker from remote operation it will used. But Tripcoil is used to serve the purpose of tripping the breaker while current exceeds the certain limit(Due to overload or fault).This is the basic differece between shunt & trip coil.
| Is This Answer Correct ? | 33 Yes | 4 No |
Post New Answer View All Answers
WHAT CAUSED THRESHOLD VOLTAGE TO EXIST?
define superposition theorem thevnin theorem ,norton theorom?
how many single tension hardware are required on a double circuit transmission tower?
what is the voltage rating of chiller unit sensors
Is the theorem applicable to ac sources?
how we can set the IDMT relay.
what is the advantage of connecting capacitors in delta than in star?
Why different Pressure switch used in marine boiler water circulation system
what topics we have to concentrate for power grid et.written test.and tell what to read for english synonyms and antonyms.
Please nybody say, weather the result of Bharat Oman is declared or not? Probable date of declare???????
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
What are the different types of dams?
Can 4pole (3 phase+neautral )RCCB proper functioning in only 3 phase load (no neautral, no Earth) ?
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
