Answer Posted / rahul
copper loss depends on current andiron loss depends upon
voltage.hence the total loss in a transformer depends upon
volt-ampere(va) so rating of transformer is given in VA
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
i karmveer bharti persuing b.tech . plz send me syllabus and name of reference books. for preparation of section eng.
what is meant by poly phase induction motor ? how its operating by single phase or three phase?
how maney type tempereture measurement ?
what is a vector protection in transformer
What does ampere turns shows?
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
How to check the cable fault / hv test of transformer cable.
HOW can i REuse the fused MLL LAMPS & GLS LAMPS at our factory
use of choke in APFC panels
what is the relation between size of the anteena and wavelenghth of radiated wave
what is high and low cut off voltage of BB and DG at SPS????????
how we calculate electrical load on a building according to area?
what is plunger and what's the use of it in motor alignment?
what is saturation kit?which use above 15 kw motors panel side.
