Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ali faozy
if the control valve has i/p &postioner we need [ 4 to 20 ]
milliamper dc source , 140 kpa air supply for i/p and 700
kpa for positioner [depending on positioner supply
recommendation]
we need also to calibrate the strock indicator for fully
open and fully close positions
if the control valve has no i/p & positioner then we need
air signal source of [20 to 100]kpa depens on control valve
design
and 700 kpa air supply for valve supply
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is intrinsic safety mean.
Name different types of bourdon tubes.
why fuse block is not used for AI signal?
what is scale factor of proximitor & unit of the vibration.
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
How we connect a instrument with ground, Give brief explanation with help of diagram?
god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies
How to interfacing microcontroller with a DC motor
send me last 5 years questions asked in rrb chennai, for section engineer
How u measure the massflow in orifice flow measurement techniques
What is the difference between modbus,fieldbus & profibus
hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
Explain signal isolator
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
