Answer Posted / santoshvarma

You can find the faulted location with the help of multimeter.

Measure the capacitance at both the ends,between faulted
phase with respect to earth.
For one end if it is C1 and for other end it is C2. And
total length of cable is L and Capacitance is C.

Then by using the below formula, you can find the faulted
location

LC=L1c1+L2c2

why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.

2206

---

how to get bearing & winding temperature of an induction motor?

2095

---

Why do we use center tap transformer that used with portable tools

2308

---

how we can calculate chiller required ampear?

2114

---

how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)

2033

---

What are the conditions to be satisfied for parallel operation of dc generators?

1139

---

Determine the BTU size of an aircon for 20 sq metre room

1918

---

What is ramp signal?

1165

---

why different series of vfds (like allenbradley)are used in industry ?

2358

---

Alternator rotor earth fault relay circuit

2109

---

Witch do depand of Power factor and theory of power factor?

2152

---

Can you tell me more about pu systems (per unit systems )calculation in large power systems? how to get the base for voltage and power in generator, transformator and transmission lines?

2344

---

what are inherent currents?

2084

---

Can you explain about Restricited earth fault protection scheme

1910

---

dg earth connect only in the amf panel or not why

2146

---