Interested to Buy Any Domain ? << Click Here >> for more details...
HOW GENERATING END VOLTAGE LEVEL (6.6 KV/ 10.5 KV/ 11 KV/
13.5 KV) DECIDED IN POWER PLANT. ON WHAT FACTORS THE
GENERATING END VOLTAGE DECIDED, & WHAT IS THE CALCULATION
USED FOR THIS.
- 3 Answers
- 21183 Views
- Areva, Cognizant, I also Faced
- E-Mail Answers
Answer Posted / sumit
generating voltage depends on the power (kva or mva).if
power is incresed voltage will be increased also.by
increasing the voltage we can reduce the current &
conductor size .if cndctr size will be reduce cost reduce
also.
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
What is the tension required for the 25000 CFM AHU belt
Give details on how you intend to handle a challenging position you are posted to manage unexpectedly as a company staff?
what are the factors to be considered while design the breaker either HT or LT??
Why Neutral Isolation is required?
When can we take Neutral as common neutral link?
difference between servo motor and synchronous motor
How equivalent impedance is calculated in thevenin theorem?
What is force on a conductor in a magnetic field ?
what is the difference between Central Battery System and UPS in applications and uses? and why UPS suitable for Computers and central battery for emergency lighting?
whati s the sludge current in ups
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
In what condition the HT fuse breakes?
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
What is a signal flow graph?
