WHAT IS THE DIFFRENCE BETWEEN EARTHED AND UNEARTHED CABLE
(XLPE)?
Answer Posted / b. ramachandra rao
Cables of 6.35/11 kV grade (earthed system) are
suitable for use on 6.6/6.6 kV (unearthed system) also.
But is it true other way as well?
Can Cables of 6.6/6.6 kV grade (unearthed system) are
suitable for use on 6.35/11 kV (earthed system) also.
Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
What is the difference between diesel generator engine with and without turbo charger with the same capacity?
ratings of lightning arrester
What is creepage distance..... what will be the value for different voltage level
I am having dual speed motor of cromton greaves make of 3.7 KW -1400 rpm and 5 KW - 900 rpm. Please let me know groups and winding connction for rewinding purpose.
how did i get the competency certificate as electricle supervisor. iam completed my b.tech.but i dnt have any experince, this certificate is required for applyng ongc mangement trainees. what should i do sir please suggested me
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
what will happen if multimeter(selector switch at DC voltage) and terminal at current is connected to DC supply?
what is the acceptable limit value for Desolve Gas Analysis/
What is q factor?
l&t switch FN 63 handle position can we change
Ceiling Fan and Storage type water heater. Discuss
how to calculation increase capacitor,increase power factor for three phase.
why the rotor current becomes in steady state during high slip region? please verify with equations.
Define demand factor?